Dinamic Opacity Dust Monitor STACK602 / VIEW580 / STACK710

Home
Products
Kansai Automation
Dust Monitor
Dinamic Opacity Dust Monitor STACK602 / VIEW580 / STACK710
STACK602 Mass Density Meter

STACK602 Mass Density Meter

General Information
Technical Information
Docs
Other Features
Product Video

STACK602 Mass Density Meter
Absolute particulate emission concentration monitoring for environmental protection
Effective for the measurement at the exit of the electric dust monitor and big duct.
No influence by adhesion on the light emitting lens or the gap of the optical axis.
Measurement range 15m Max.

Model	STACK602 Sensor
Housing Material	ADC（epoxy coated）
Enclosure Rating	IP65
Temperature	Ambient Temp.：-25℃～+55℃ Temperature inside the exhaust gas pipe.： -25℃～+400℃（Standard） -25℃～+600℃（Heat resistant model for high temperature）
Detection Distance	1m～15m
Process Connection	Flange 50A or over
Air purge	1/4 male screw 30 to 40 litres/minute.
Cable	4-wire Shield Cable　0.5sq 50Ω/km （max.1000m Single rayout） 8-wire Shield Cable（Transmitter－Receiver）

Model	STACK602 Controller
Power Supply	90～260VAC 1A(50/60Hz)
Outputs	DC4～20mA （isolated, resistance load max.500Ω） Serial RS232C・RS485 Relay contact 1cX2(AC250V 2A)
Inputs
Sensor connection point	1
Resolution	< 0.01mg
Self-checks	Zero and Span checks
Memory capacity	（1 Sensor） Short：7 days @ 1 minute Pulse data：2 hours @ 1 second Alarms：500 entries
Housing Material	ADC（epoxy coated）
Enclosure Rating	IP65
Display	LCD（Bar-graph,Values,Trend screen etc）
Temperature	-25℃～+55℃

Operating Principles

The variation of light rays that pass over the duct is monitored and the ratio of the amount of light received and the variation (dynamic opacity) is calculated and detected.

Dinamic Opacity Dust Monitor STACK602 / VIEW580 / STACK710

STACK602 Mass Density Meter

Partners